Saving Your iPad When It Has Been in Water: Dos and Don’ts

You’ve been dreading it happening and then it finally does happen – splash – your iPad just made its way into water. Dropping your iPad into the pool, sink, or spilling water on it is likely your worst nightmare, but the chances of it happening are actually quite high and one of the most common reasons why people seek out iPad repairs.

Water and electronics do not mix and if your device has been dropped in water, it could suffer some serious damage, especially if the logic board gets wet.

If your first instinct is to take the iPad out of water and turn it on to make sure it still works, you are not alone. Most people do this as a natural reaction, but it can actually do more harm than good.

Below, we will discuss some of the most important dos and don’ts when it comes to saving your iPad from water. If you follow these do’s and don’ts, you have a good chance of your iPad working even after a liquid disaster.

DO: Remove the Case

You should remove any case that you have on your iPad as this will ensure any trapped water leaks out of the device.

DO: Shake Out the Water

Removing as much water as possible is the number one goal at this very moment. To help you do this, take the time to shake the water out of your device. You may not need to shake it too much depending on how much liquid it was dropped into, but definitely have some paper towels handy.

DO: Take Out the SIM Card

Once you have drained the water from your device, you want to remove the SIM card from it. This can help you save the SIM card from any serious water damage.

DO: Use Silica Packets If You Have Them

If you have some silica packets lying around, go ahead and use them. They can help soak up and absorb some of the moisture that may be left behind in the device. Tip: Should you not have any silica packets on hand, you can usually find them at the local craft or hardware store.

DON’T: Turn the iPad On

While it is tempting to turn the iPad on just to make sure it still works, you will do a lot of damage by turning it on. You should skip turning it on at all costs.

You should wait a minimum of 24 hours (more is better) until you attempt to turn it on. You should only turn it on if all the water and moisture has dried up.

Tip: Keep your iPad in an upright position to help it drain.

DON’T: Put it in Rice

You have probably heard the saying that you should place your iPad in rice if it has been dropped in water. While it may help absorb some moisture from the device, you run the risk of some of the rice getting stuck in the smaller holes and openings. This can cause more damage and it is usually a good idea to just skip it.

DON’T: Use High Heat

If someone tells you to use a hair dryer or another means of high heat to dry out your iPad, don’t do it. The high heat will only cause further damage to your device.

New York iPad Repair Can Fix a Water-Damaged iPad

If your iPad has been dropped in water, it is important to bring it into our service center. Our team of friendly and reliable iPad experts will look it over and perform the necessary repairs.

New York iPad Repair has been named number one locally by customers due to our affordable prices and fast services. Many of our services are completed the same day for your convenience. Give us a call today to schedule an appointment for your needed iPad repairs or bring your device to our service center now.

Leave a Reply

Your email address will not be published. Required fields are marked *